b. INSTALLATION
TM 9-2330-390-14&P
4-53.
FRONT DRAWBAR REPLACEMENT (Con't).
NOTE
4.
5.
Perform steps 4 through 7 if components are damaged or if replacing front drawbar.
Remove data plates (see paragraph 4-105).
Remove safety chains mounting (see para-
graph 4-52).
6.
7.
Remove dummy couplings (see paragraph 4-87).
Remove caster wheel assembly (see para-
graph 4-91).
8.
If bushings (8) are damaged, notify Direct Support to remove from front drawbar (7).
1.
2.
3.
4.
5.
6.
7.
8.
If removed, have Direct Support install bushings (8) in front drawbar (7).
If removed, install caster wheel assembly (see paragraph 4-91).
If removed, install dummy couplings (see paragraph 4-87).
If removed, Install safety chains mounting (see paragraph 4-52).
If removed, install data plates (see paragraph 4-105).
If removed, install hitch pin and safety pin (5) for handle stowage and detent pin for telescopic brace with
lanyard assemblies (6) (see paragraph 4-99).
Install two new grease fittings (3) on front drawbar (7).
Install front drawbar (7) on steering link (2) with bolt (1) and new locknut (4). Torque locknut to 500-550 lb.-ft.
(678-746 N•m).
Follow-on Tasks:
Install intervehicular air hoses (see paragraph 4-72).
Install safety chains (see paragraph 4-51).
Lubricate front drawbar (see Lubrication Instructions, Chapter 3, Section I).
Change 3 4-115
