TM 9-2330-390-14&P
1-10.
EQUIPMENT CHARACTERISTICS, CAPABILITIES, AND FEATURES (Cont).
NOTE
There is no spare tire mounted on the dolly set. A spare must be obtained from the
towing vehicle or the motor pool.
(1)
tire changing flexibility using either towing vehicle jack or dolly set hydraulic system to raise wheel
and tire assemblies off the ground.
(2)
towing, electrical, and airbrake connections on the rear dolly which allow for tandem towing of a
second (empty) dolly set.
(3)
standard lift and tie-down points (D-rings) on front and rear axles.
c.
The M1022A1 can be equipped with a side lift kit, installed by Direct Support Maintenance. With the side
lift kit installed, the dolly set is used as a container-handling device as well as a transport device. Containers can be
loaded and unloaded to or from flatbed trucks, trailers, and railcars. They can be cross-loaded between modes of
transportation and transported over short distances. Features of the M1022A1 equipped with side lift kit are:
(1)
capability to side lift a 20 ft (6.1 m) container with a maximum payload of 15,000 lb (6810 kg) on a
smooth and level grade.
(2)
maximum ground clearance at container of 58 in. (147.32 cm).
(3)
maximum towing speed of 5 mi/h (8 km/h) over short transport distances [100 ft (30.5 m)].
(4)
operational cycle performed by four trained personnel in 30 minutes or less.
d.
The M1022A1 can be equipped with a cold start kit, installed by Unit Maintenance. This allows engine to
start in extreme temperatures of -26°F to -50°F (-32° to -46°C).
Change 1 1-5
