TM 9-2330-390-14&P
4-35.
FORWARD JUNCTION BOX REPAIR (Con’t).
Dry cleaning solvent, P-D-680, Is toxic and flammable. Always wear protective
goggles and gloves, and use only In a well-ventilated area. Avoid contact with skin,
eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open flame or
excessive heat. The solvent’s flash point is 100°F-138°F (38°C-59°C). If you
become dizzy while using cleaning solvent, Immediately get fresh air and medical help.
If solvent contacts eyes, Immediately wash your eyes and seek medical attention.
1.
2.
3.
4.
Clean all metal parts with dry cleaning solvent and dry with a clean rag.
Clean all other components with a clean rag.
Inspect forward junction box and receptacle cover for damage. Replace damaged parts.
Inspect receptacle connector and cable assembly for loose or broken wires and terminal lugs, and damaged
connector inserts and pins. Replace damaged parts (see paragraph 4-26).
1.
Install two screws (4), new external-tooth lock-
washers (20), and new locknuts (19) on forward
junction box (9).
2.
Install marker strip (18) and terminal block (1) on
forward junction box (9) with two screws (21), flat-
washers (17) and new locknuts (16).
Position receptacle connector (13) and cable
assembly on cover (2) with alinement key (10) at
12 o’clock position. Position receptacle cover
(11) on cover with hinged side facing 12 o’clock
position.
3.
Install four capscrews (12), new lockwashers
(14) and nuts (15).
4.
4-57
