TM 9-2330-379-14&P
SERVICE BRAKE ASSEMBLY - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
DISASSEMBLY - CONTINUED
6
Plunger
Two plunger
Remove two guide screws (16) and two
housing (3)
guide screws (16)
gaskets (17) from the plunger housing (3)
and two gaskets
on left side of brake assembly. This
(17)
plunger housing contains two non-adjusting
anchor plungers (solid).
7
Two plunger
Remove adjusting pawl assemblies (18).
guide and adjust-
(Use a small magnet to remove pawl if
ing pawl assem-
necessary from the plunger housing (3)
blies (18)
on the right side of the brake assembly.)
This plunger housing contains two
adjusting plungers.
8
Left side
Two plunger
Pry two plunger anchor seals (19) loose
plunger
anchor seals (19)
and remove two anchor (solid) plungers
housing (3)
and two anchor
(20).
(solid) plungers
(20)
9
Right side
Two adjusting
Pry two plunger seals and retainers (22)
plunger
bolt assemblies
loose and remove two adjusting bolt
housing (3)
(21), two plunger
assemblies (21), two adjusting sleeves
seals and re-
(actuators) (23) and two adjusting
tainers (22), two
plungers (24).
adjusting sleeves
(actuators) (23),
and two adjusting
plungers (24)
NOTE
Proceed to next step to determine proper
function of adjusting bolt assembly.
10
Adjusting
Retainer (25),
Disassemble adjusting bolt assembly (21)
bolt
spring (26),
into components, retainer (25), spring
assembly
detent washer
(26), detent washer (27) and adjusting
(21)
(27) and adjust-
bolt (28).
ing bolt (28)
4-106
