TM 9-2330-275-14&P
2-11. ATTACHING DOLLY SET TO SHELTER (Con’t).
(4) Disconnect air hose quick-disconnect connector (8) from power cluster (9) on rear dolly (1). Coil
air hoses (5) on front dolly (4).
(5) Disconnect intervehicular cable (2) from distribution box (3) on rear dolly (1). Coil intertvehicular
cable (2) on front dolly (4).
NOTE
Steps 6 through 9 apply only to the M832 (SN J089-001 thru 159 and J017-160
thru 360). Skip steps 6 through 9 if working with any other model.
(6) Rotate bearing post counterclockwise to loosen wheel. Lift bottom of caster assembly (10),
remove pin (11 ), and remove caster assembly (10) from brackets on rear dolly (1).
(7) Place pin (13) in upper mounting block (12) and rotate caster assembly (10) down into lower
mounting block (14) to install caster assembly (10) at mounting point. Insert pin (11).
(8) Rotate control valve (16) clockwise to close valve.
2-16
