DRAWBAR ASSEMBLY MAINTENANCE - cont - TM-9-2330-275-14P

DRAWBAR ASSEMBLY MAINTENANCE - cont - TM-9-2330-275-14P_247

DRAWBAR ASSEMBLY MAINTENANCE - cont - TM-9-2330-275-14P_249

TM-9-2330-275-14P Trailer Tank Water: 400 Gallon 1-1/2 Ton M149 (NSN 2330-00-542-2039) M149A1 (NSN 2330-00-832-8801) M149A2 (2330-01-108-7367) Manual
Page Navigation
234

TM 9-2330-275-14&P 4-54. DRAWBAR ASSEMBLY MAINTENANCE (Con’t). 6. Remove eight nuts (8), Iockwashers (9), and screws (21) from two rubber mounts (7) on drawbar (20). Discard Iockwashers. NOTE For the MS32 (SN J089-001 thru 159 and J017-160 thru 350), drawbar and coupler iInclude stops. Perform stop 7 for the M832 (SN J089001 thru 159 and J017-160 thru 350). 7. Remove two nuts (23), screws (27), stops (25), and lockwashers (24) from drawbar adapter (26). Discard lockwashers. 8. Remove drawbar adapter (6 or 26) and two rubber mounts (7) from drawbar (20). 9. Remove eight nuts (4) and lockwashers (5) from drawbar adapter (6 or 26), and remove two rubber mounts (7) from drawbar adapter (6 or 26). Discard Iockwashers. c. ASSEMBLY NOTE The front of rubber mount has a slight vertical slope. An arrow is located in center hole of each mount, which indicates the sloped side. Position each rubber mount with sloped side facing the front of the drawbar. 1. Install two rubber mounts (7) on drawbar adapter (6 or 26) with eight nuts (4) and new lockwashers (5). Torque nuts to 55 lb.-ft. (75 N•m). 2. Install two rubber mounts (7) and drawbar adapter (6 or 26) on drawbar (20) with eight screws (21), nuts (8), and new iockwashers (9). Torque nuts to 85 lb.-ft. (115 N•m). M832 (SN J089-001 thru 159 and J017-160 thru 350 Only) 4-144

Privacy Statement
Press Release
Contact