REAR AXLE REPLACEMENT (M832).

TM-9-2330-275-14P Trailer Tank Water: 400 Gallon 1-1/2 Ton M149 (NSN 2330-00-542-2039) M149A1 (NSN 2330-00-832-8801) M149A2 (2330-01-108-7367) Manual
Page Navigation
168

TM 9-2330-275-14&P 4-34. REAR AXLE REPLACEMENT (M832). This Task Covers: a. Removal b. Installation Initial Setup: Equipment Conditions: . Platform removed (M832 except SN J089-001 thru 159 and J017-160 thru 350) (para 4-52). l Platform removed (M832 SN J089-001 thru 159 and JO17-160 thru 350 only) (para 4-53). l Handbrake lever removed (para 4-36). • Axle spindle removed (para 4-37). l Hydraulic brake lines and fitings removed (para 4-40). . Hydraulic pump removed (M832 except SN J089- 001 thru 159 and J017-160 thru 350) (para 4-75). l Hydraulic pump removed (M832 SN J089-001 thru 159 and J017-160 thru 350 only) (para 4-78). l Power cluster removed (para 4-39). l Alining rods disconnected (para 4-65). . Rear stabilizer bar removed (para 4-66). l Wiring harness removed from rear axle (para 4-25). Materials/Parts l Eighteen lockwashers • Two rivets Tools/Test Equipment: l General mechanic’s tool kit l Common no. 1 shop set Personnel Required: Two a. REMOVAL 1. 2. 3. 4. s. 6. 7. NOTE The M832 (SN JO89-001 thru 159 and J017-180 thru 350) does not have a positioning lever. Disconnect right and left pins (4) from ends of positioning lever (12). Remove positioning lever. Chisel head off right and left rivets (2) and use a drive pin punch to remove rivets (2) from hole. Remove right and left wire rope assemblies (3) from rear axle (1). Discard rivets. Remove two bolts (6) and lockwashers (7) and shroud (5) from rear axle (1). Discard Iockwashers. Disconnect pin (13) of wire rope assembly (3) from rear axle (l). Remove screw(14) and wire rope assembly (3) from rear axle (l). NOTE For the M832 (SN J089-001 thru 159 and JO17-160 thru 350), mounting bracket 12255119 (8) is replaced by rnounting bracket 12446800 (11). Remove four screws (9) and lockwashers (10) and mounting bracket (8 or 11) from rear axle (l). Discard lockwashers. While supporting dolly, remove eight screws (18) and lockwashars(17), two trunnion cape (16), and rear axle (1) from dolly. Discard lockwashers. Remove four nuts (21 ), lockwashers (20), bolts (19), and trunnion bearings (15) from rear axle(1). Discard Iockwashers. b. INSTALLATION] 1. Install four trunnion beatings (15) on rear axle (1) with four bolts (19), new lockwashers (20), and nuts (21). 4-78

Privacy Statement
Press Release
Contact