4-31. STEERING KNUCKLE REPLACEMENT.
This Task Covers:
a. Removal
c. Installation
b. Cleaning and Inspection
Initial Setup:
Equipment Conditions:
Materials/Parts:
• Axle spindle removed (para 4-37).
• Grease (Item 7, Appendix E)
l Tie-rod disconnected (para 4-29).
. Dry cleaning solvent (Item 14, Appendix E)
. Nonelectrical wire (as required) (item 19,
Tools/Test Equipment:
Appendix E)
l Two gaskets
l General mechanic’s tool kit
l Six Iockwashers
• Common no. shop set
a.
REMOVAL I
NOTE
Steering knuckles for all dolly sets are similar. The M689 steering knuckle is
shown. The M832 steering knuckle (SN J089-001 thru 159 and J017-160 thru
360) Includes a steering stop plate.
1.
Remove nonelectrical wire (2), three screws(1) and lockwashers (3), cap (4), and gasket (5) from top
bottom of steering knuckle (6). Discard nonelectrical wire, gaskets, and Iockwashers.
and
4-71
