4-25. BRANCHED WIRING HARNESS REPLACEMENT.NOTEThere are two ground wires at roadside rear light and one ground wire at curbside rearIight.3. R e m o v e three screws (4), Iockwashers (3), and ground wires (5) of branched wiring harness (10) from lightbrackets (2). Discard lockwashers.NOTEClamps holding brake lines are also removed when branched wiring harness clampsare removed.4.Remove six screws (7), lockwashers (8), and clamps (9) from rear dolly. Discard lockwashers.5.Remove branched wiring harness (10) from rear dolly.[b.INSTALLATION I1.Position branched wiring harness (10) to rear dolly.2.Connect connectors (11) of branched wiring harness (10) to wires (1) of rear lights (8).NOTEThere are two ground wires at roadside rear light and and ground wire at curbside rearlight.3.Connect three ground wires (5) of branched wiring harness (10) to light brackets (2) with three new lockwasshers(3) and screws (4).NOTEClamps holding brake Iines are also Installed when branchedwlrlngharness clamps areinstalled.4.Install branched wiring harness (10) to rear dolly with six clamps (9), new lockwashers (6), and screws (7).FOLLOW-ON TASKS:l Install branched wiring harness to rear distribution box (para 4-20 or 4-21).. Connect Intervehicular cable 10 distribution box and towing vehicle (para 2-14).l check operation of lights.4-57
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
