TM 9-2330-275-14&P
4-24. COMPOSITE STOPLIGHT-TAILIGHT MAINTENANCE (M832 AND M840) (Con’t).
4.
Install two lamps (4 and 5) and two lamps (14) by pushing in and turning clockwise.
5.
To remove LED (15), insert a small flat-tipped screwdriver into slot inside center hole of LED. Firmly push in
LED, turn counterclockwise slightly, and remove LED.
6.
To remove LED (13), insert a small flat-tipped screwdriver into slot on left sided LED. Remove cover, allowing
access to slot in center hole. Firmlv push in LED with screwdriver in center hole slot, turn counterclockwise
slightly, and remove LED.
7.
Install two LEDs (13 and 15) by snapping into place with hand aplication.
8.
If removed, install new preformed packing (3) in door (l).
9.
Install door (1) on body (6) and tighten six screws (2).
b .
REMOVAL
1.
Tag and disconnect four connectors (9) from branched wiring harness.
2.
Remove two screws (8), four Iockwashers (7), and body (6) from rear dolly. Discard lockwashers.
3.
Remove two screws (1O), four washers(11), and composite light bracket(12) from rear axle.
4.
Inspect bracket (12) for wear or damage. Discard if damaged.
c.
INSTALLATION
NOTE
If composite light bracket was discarded and replacement bracket has no
holes, see Appendix G for fabrication instructions.
1.
Install two screws (10), four washers (11), and bracket (12) on rear axle.
2.
Install body (6) on rear doily with four new Iockwashers (7) and two screws (8).
3.
Connect four connectors (9) to branched wiring harness.
FOLLOW-ON TASKS:
l Connect intervihcular cable to towing vehicle (para 2-14).
l Check operation of light.
4-55
