TM 9-2330-275-14&P
4-23. BLACKOUT STOPLIGHT REPLACEMENT (M689).
This Task Covers:
a. Removal
c. Assembly
b. Disassembly
d. Installation
Initial Setup:
Equipment Conditions:
Tool/Test Equipment:
l Dolly parked on level surface with handbrakes
l General mechanic’s tool kit
applied (pars 2-2).
NOTE
l This paragraph applies to the M689 only.
l If only replacing the lamp, the stoplight doss not have to be removed from
vehicle. Perform disassambly and assembly procedures only.
a.
REMOVAL I
1.
Disconnect and remove wiring harness connectors from blackout stoplight (1).
2.
Remove bolt (6), blackout stoplight (1), and attached wiring from mounting bracket.
[b.
DISASSEMBLY]
1.
Remove two bolts (5), retainer lens (2), and gasket (3) from blackout stoplight (1) housing. Discard gasket.
2.
Push in on lamp (4) and turn counterclockwise to remove.
4-52
