TM 9-2330-275-14&P
4-28. CONNECTING LINK REPLACEMENT
This Task Covers
a. Removal
c.
Installation
b. cleaning and Inspection
Initial Setup:
Equipment Conditions:
Materials/Parts
l Drawbar removed (para 4-54).
l Grease (Item 7, Appendix E)
l Tie-rods removed (para 4-29).
l Dry cleaning solvent (Item 14, Appendix E)
Tool/Test Equlpment
l Three Iockwashers
l General mechanic’s tool kit
l Four locknuts
l common no. 1 shop set
[a. REMOVALI
NOTE
l Porfotm steps 1 through 5 for M689.
l Perform steps 6 through 10 for M832 and M840.
1.
Remove four locknuts (13), screws (2), and bracket (3) from bracket support (1). Discard locknuts.
2.
Remove two screws (4), Iockwashers (5), and bracket support (1). Dlacard lockwasher.
3.
Remove screw (6), Iockwasher (7), and pin (8). Discard Iockwasher.
M689
4 - 62
