TM 55-8115-200-23&P
Figure 2-2. Patching With Repair Kit.
CAUTION
Open-flame devices will not be used.
(b) Using repair kit MIL-R-58047 (CE) or
MIL-R-19907C (NSN 2090-00-372-6064), apply
the low viscosity epoxy to cloth, nylon, or the like,
which has been cut to a size of at least two to three
inches greater in each direction of the hole to be
covered.
(c) Affix patch over the damaged area.
(d) Tape the patch in vertical and horizon-
tal directions such that the patch will not slip while
curing. It will take approximately two hours for
the patch to adhere properly.
(3) To repair the sheet metal panels of the
container when laden and the damaged area is
larger than 144 square inches (929.10 sq cm),
empty the container and refer it to direct support
maintenance.
2-4 Change 4
