TM 10-8340-243-13&P
0002
Tent Fabric Assemblies
Plain Wall Assembly. The plain wall (Figure 2,
Item 1) is
constructed of
mildew and flame resistant
polyester duck cloth and is approximately 12 feet, 6 inches wide by 8 feet high. On the inside, eight quick
release male fasteners are located approximately 18 inches apart along the top edge. Four female quick
release fasteners are also located along the top, spaced about 40 inches apart. Seven buckle assemblies
with quick release female fasteners are located approximately 12 inches apart and 22 inches from the
edge along each side, with three more approximately 5 feet apart and 24 inches above the bottom edge.
A 2-inch wide hook fastener strip is located along the top, the upper corners, and the outer edge of the
right side. An identification label is sewn to the inside of the wall. On the outside, four roll-up straps are
located approximately 40 inches apart along the top, and seven small buckle assemblies with quick
release female fasteners are located approximately 12 inches apart and 22 inches from the edge along
the right side. In addition, seven side straps with quick release male fasteners are located about 12
inches apart along the outer edge of each side. A 2-inch wide pile fastener strip is located along the top,
the upper corners, and the fold line of the right side. One plain wall is issued with each MCPS.
1
Figure 2. Plain Wall Assembly (Type I
Shown).