Figure 3–24. Securing tent liner arch pipe to purlin.
c. End Assembly B.
(1) Raise and attach end assembly B to
the tent end section and vehicle door as de-
scribed in a(12) through (7) above.
(2) Lace becket lacing of installed in-
termediate assembly through the grommets
of end assembly B as described in b(2) above.
(3) Pull the hoist chain to raise the ve-
hicle door assembly. Secure the hoist chain
to the chain retainer.
3-14. Wiring Harness Installation
a. Attach the circuit breaker (A, fig. 3–26)
to its mounting bracket on the doorpost assemb-
ly (B, fig. 3-26). A mounted circuit breaker
is shown in figure 3-26C.
b. If the tent liner has been installed, secure
the 27-foot cord to the tent liner arch pipes,
using the hanger hooks and running the cord
over the vehicle door. If the tent liner has not
been installed, attach the cord to the purlins
of the tent frame running the cord over the
vehicle door.
c. If the tent liner has been installed, secure
the 16-foot cord to the tent liner arch pipes
on the near side of the tent, using the hanger
hooks. If the tent liner has not been installed,
attach the cord to the purlins of the tent frame.
d. Connect the socket of the lighting and
outlet assembly to either cord assembly.
e. If the tent liner has been installed, secure
the lighting and outlet assembly to the tent
arch pipes; if not, attach the assembly to
the purlins.
j. Attach the 6-foot cord from the circuit
breaker to an outside power source.
g. If an additoinal lighting and outlet as-
sembly is required, it may be connected to the
installed assembly.
3-29
