Figure 3-23. Raising tent liner end section to top of tent.
(fig. 3–24). Secure the remaining arch pipes
to the purlins on both sides of the tent in a
similar manner.
(5) Secure the left and right walls of the
liner end assembly to the tent end section by
means of tie tapes and D-rings (A, fig. 3–25).
(6) Close the vehicle door.
(a) Release the door control arms from
the door control arm locks.
Caution: Use the door control arm
ropes to guide the doorpost top assemblies to
the closed position slowly.
(b) Release hoist chain retainer and
pull the hoist chain to lower the vehicle door.
(7) Secure the vehicle door portion of the
liner assembly to the vehicle door by means
of the tie tapes and D-rings (B, fig. 3-25).
3-28
(8) Pull the hoist chain to raise the ve-
hicle door assembly. Secure the hoist chain to
the chain retainer.
b. Intermediate Assembly.
(1) Raise an intermediate liner assembly
to the top of the tent as described in a(3)
above. Secure the center arch pipe to the top
center long purlin, using the S-hook and chain
assemblies as described in a(4) above.
(2) Lace the becket lacing of the liner
end assembly A through the grommets of the
intermediate section. Begin lacing at the bottom
of one side of the liner and continue until
the bottom of the other side is reached. Secure
the last lacing with a knot.
(3) Attach the remaining intermediate
liner assemblies in a similar manner.
