TM 10-7360-211-13&P
Change 7 2-6.1
2-6. ASSEMBLY AND PREPARATION FOR USE (CONTD).
WARNING
ELECTRIC SHOCK. HIGH VOLTAGE is used in the operation
of this equipment. DEATH ON CONTACT may result if
personnel fail to observe safety precautions. Never work on
electrical equipment unless there is at least one other person
nearby who is familiar with the operation and hazards of the
equipment. That person should also be competent in giving
first aid.
Disconnect equipment from power source before performing
any maintenance. Be careful not to contact high voltage
connections when removing, installing, or operating this
equipment. Whenever possible, keep one hand away from the
equipment to reduce the hazard of current flowing through vital
organs of the body. Voltages as low as 50 volts may cause
death.
For artificial respiration, refer to FM 21-11. Do not stand in
water while handling live power cords or electrical shock may
result. Position all power cables so that they are out of the way
during operation and are not lying in water. Prior to
installation, assure power cables are not damaged or frayed.
Prior to installation, assure power cables outer jackets are not
cut or damaged and there are no exposed wires.
1. Insert one light-hanging strap (1) through the loop in the tent light hanger (2).
2. Insert one end of that light-hanging strap (1) through the loop in the other end of the same light-hanging strap (1).
3. Pull the light-hanging strap (1) tightly through until it knots at the loop of the tent light hanger (2). Repeat this
procedure for the second strap.
NOTE
Ensure the bulb is facing the ground and the reflector is on top.
1
2
6
3
4
5
