TM 10-7360-211-13&P 2-4     Change 7 Table 2-2. Operator's Preventive Maintenance Checks and Services B-Before Operation                 D-During Operation               A-After Operation Item No. Interval Item to be inspected Procedure Equipment Not Ready/Available If: B D A 1     Tent IAW TM 10-8340-224-13 or TM 10-8340-240-12&P. 2    Lantern/ Electrical Light Check for leaks, dents, broken glass and safety of operation.   Ensure the electrical light tube is not Light tube is cracked or   Broken.  Replace light cracked or broken.  Ensure the cable ties on the light are secure.    Tube.  Cable assembly is torn/cut. Visually ensure the light bulb is not cracked or broken.    Light bulb is cracked or broken.  Notify unit maintenance. Ensure that the light bulb is working. Inspect the light- hanging strap for tears or fraying.  Ensure cable assembly is not torn/cut.  Ensure the extension cord does is not torn or cut. Light-hanging straps are   torn or frayed.  Extension cord is torn/cut. 3    Storage Rack Inspect for damaged frame or front cover. Check that Assembly rack units stack properly. Check wire mesh for bends, breaks or broken welds at the tabs. Check that front cover/shelf is not warped. 4 Sink Assembly Check assembly for leaks or clogged drains. Check for damage or deformation that would prevent Sinks leak or do not drain.   Components will   installation, assembly or operation of components. fit not together or are damaged. Ensure the rear of the sink is aligned with the rear of the burner rack. 5  Sink Drain Check assemblies for leaks or clogged hoses. Check Hose Assembly coupling halves for free operation. Check to insure that each hose end is securely attached with a hose clamp. Insure that hose clamp is tight. 6    Sink Immersion Check for corrosion, bent or broken mesh. Check for Rack loose wire ends. 7    Thermometer Check thermometer for damage. Insure the stem is not bent and the dial is legible. Inspect the glass for breaks. Check the hex nut on top of stem for tightness. 8a      M2 Burner Unit Perform PMCS IAW TM 10-7360-204-13&P. 8b      MBU Perform PMCS IAW TM 10-7310-281-13&P. 9    Drain Table Check to ensure drain table is secure and sufficiently inclined to permit water to drain off. Check for bent or damaged parts.    10      Work Table Check to ensure tables are level and secure. Check for   broken welds, loose or missing rivets, clamps and brackets. 11      Fire Check to ensure charge reading is in the green and that Fire extinguisher or seal Extinguisher the seal is not broken. is missing or broken, or charge is reading in the red.