TM 10-7360-211-13&P 2-8 Change 7 2-6 ASSEMBLY AND PREPARATION FOR USE (CONTD). c. AssemblyofSinkAssemblies. Assemble the sinks as follows: WARNINGSerious injury could occur if heavy equipment is moved/lifted without sufficient personnel to do the job. Use proper physical lifting procedures or use a suitable lifting device or dolly. Wear safety shoes, gloves and other suitable protective clothing. WARNINGThe sink assembly must sit correctly on the burner rack. If the sink assembly is not installed correctly, the improper placement will block the flue and cause the heat guard and sink assembly to overheat. Keep body parts away from the heat guard. Failure to do so may cause serious injury to personnel. CAUTION Ensure the burner unit is pushed all the way back into the burner rack. Ensure the back of the sink assembly is aligned with the back of the burner rack and the burner rack tabs are inserted in the flue on the sink. When the sink assembly is properly placed on the burner rack, it will help prevent the burner from overheating. Failure to do so will shorten the life span of the equipment. CAUTION Make sure you leave enough air space between the tent wall and the sink assemblies. Frequently check for heating of the tent wall while the burner units are in use. Move the burner units further away from the tent wall if necessary to prevent possible ignition of the tent. (1) Move three sink body assemblies (1), sink adapters (2), burner racks (3), with burner units in place (4), and base racks (5) to the sink locations. (2) Place the base rack (5) in position; place the burner rack (3) with burner unit (4) on top of base rack (5). Ensure the burner unit is pushed all the way into the burner rack. (3) Place the sink body assembly (1) on top of burner rack (3).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
