TM 10-7360-208-13&P Table 2-2.   Operator's Preventive Maintenance Checks and Services B- BEFORE OPERATION    D- DURING OPERATION A- AFTER OPERATION INTERVAL PROCEDURES EQUIPMENT IS ITEM ITEM TO BE Check for and have repaired NOT READY/ NO. B D A INSPECTED or adjusted as necessary AVAILABLE IF 1 • • Tent Perform PMCS IAW TM 10-8340-224-13. 2 • Lantern Check for leaks,  dents,  broken glass and safety of operation. 3 • Storage Rack Inspect for damaged frame or front cover. Assembly Check that rack units stack properly. Check wire mesh for bends,  breaks or broken welds at the tabs.   Check that front cover/shelf is not warped. 4 Oven Inspect oven assembly for broken,  loose Door damaged lets Assembly or missing hardware,  warning decal or heat escape from components,  bent members or broken oven; or bent oven welds.   Check door for damage,  and en- racks don't hold sure it closes tightly.   Check for missing or food containers. damaged oven racks. 5 • Burner Rack Inspect for bent members or broken Bent or broken welds and Base welds. which prevent M2 Rack burner unit being used properly. 6 • Griddle Inspect for bent members or broken Griddle assembly is Assembly and welds.   Check for warped or missing physically damaged. Steam Table griddle assembly,  grease slot plug,  steam Parts are missing or Assembly table drain plug,  or griddle splash guards. loose.   Warning plate Check heat guards for adjustability.   Check is missing or illegible. for badly scratched or worn off anodized coating on griddle (over 50% on both sur- faces).   Refer to item 5 for racks.   Ensure that warning plates are properly mounted and legible. 2-4 Change 6