TM 10-5411-235-13
REPAIR OF SHELTER DOOR DRIP MOLDING
THIS WORK PACKAGE COVERS:
Replace
INITIAL SETUP:
Maintenance Level
Direct Support
Tools:
Drill (WP 0042, Table 2, Item 4)
Safety Goggles (WP 0044, Table 1, Item 35)
Riveting Tool (WP 0042, Table 1, Item 2)
Materials/Parts:
Dome Head Pop-Rivets (WP 0044, Table 1, Items 27 & 28)
Drip Molding
Sealer (WP 0044, Table 1, Item 19)
Alcohol, Isopropyl (WP 0044, Table 1, Item 7)
Cloth, Cotton (WP 0044, Table 1, Item 3)
REPLACE
REMOVE
WARNING
Drilling creates metal chips which may enter eyes and cause
serious injury. Eye protection is required.
CAUTION
Make sure the drill bit has a drill stop attached to prevent
the drill bit from exceeding a depth of one inch.
1. Remove sealant.
2. Using a drill with a #11 drill bit, carefully drill out seven rivets (2) securing drip molding (1) to
shelter.
3. Remove drip molding (1).
INSTALL
1. Locate drip molding (1) to shelter and insert seven rivets (2) through holes in drip molding (1) and
into holes in shelter.
2. Using a pop-rivet tool, secure drip molding (1) to shelter.
3. Replace sealant.
4. Prime and paint repaired panel surface in accordance with local Standard Operating Procedures
(SOP).
0035 00-1
