TM 10-5411-235-13
LIFTING RING BUMPER
THIS WORK PACKAGE COVERS:
Replace
INITIAL SETUP:
Maintenance Level
Direct Support
Tools:
General Mechanics Tool Kit (WP 0042, Table 2, Item 1)
Drill (WP 0042, Table 2, Item 4)
Riveting Tool (WP 0042, Table 1, Item 2)
Safety Goggles (WP 0044, Table 1, Item 35)
Materials/Parts:
Bumper
Rivet, Dome Head (WP 0044, Table 1, Item 27)
Rivet, Dome Head (WP 0044, Table 1, Item 28)
Alcohol, Isopropyl (WP 0044, Table 1, Item 7)
Cloth, Cotton (WP 0044, Table 1, Item 3)
Sealer (WP 0044, Table 1, Item 19)
REPLACE
REMOVE
WARNING
Drilling creates metal chips which may enter eyes and cause
serious injury. Eye protection is required.
CAUTION
Make sure the drill bit has a drill stop attached to prevent
the drill bit from exceeding a depth of one inch.
NOTE
A shim is located under the front bumpers and a longer rivet
is installed in the most forward hole of each.
1. Using a drill with a #11 drill bit, carefully drill out two rivets securing bumper (1) to shelter and
remove bumper.
INSTALL
1. Position bumper (1) to shelter.
2. Align holes and secure rear bumper (1) in position with two rivets (2).
3. Apply sealant.
4. Prime and paint surface panels in accordance with local Standard Operating Procedures (SOP).
0034 00-1
