TM 10-5411-235-13
DIRECT SUPPORT TROUBLESHOOTING
GENERAL. This section contains troubleshooting information for malfunctions which may develop
in the LMS Type 1 Shelter. Fault isolation is limited to those components which may be repaired or
replaced at the direct support level. Table 1 lists the common malfunctions you may encounter
during operation or maintenance of the shelter. Each malfunction identifies a test or inspection
followed by a corrective action. These tests or inspections and corrective actions should be
performed in the order listed. This manual cannot list all malfunctions that may occur. If you
encounter a malfunction that is not listed or that cannot be corrected by the listed corrective actions,
notify your supervisor.
SYMPTOM INDEX.
MALFUNCTION/SYMPTOM
TROUBLESHOOTING PROCEDURE
SHELTER WALLS, ROOF, FLOOR
Interior or Exterior Dents or Punctures
27.1
NOTE
Punctures can cause a loss of EMI/RFI integrity. Repairs
should be performed as soon as possible.
SEALS/GASKETS
27.2
Drain Plug Not Sealing Properly
MOUNTING
Difficulty Accessing Shelter Roof from Steps
27.3
Lifting Rings Contact Shelter Wall
27.4
DOOR ASSEMBLY
27.5
Personnel Door Binding or Fails to Close Securely
27.6
NOTE
Be sure to read all warnings in front of the manual before
troubleshooting.
0027 00-1
