TM 10-5411-224-14
4-18. DOOR ASSEMBLY - continued.
INSTALLATION
1. Locate shims (17) and strike plates (16) to door (1) and secure using two screws (14) and washers (15).
WARNING
Door assembly weighs in excess of 50 pounds use two personnel to support door when
installing or serious injury may result.
CAUTION
Door assembly weighs in excess of 50 pounds use two personnel to support door when
installing to prevent damage to the door or shelter.
1. Locate door (1) to shelter positioning hinges (13) over the holes.
2. Secure the three door hinges (13) to shelter using twelve screws (12).
3. Align holes at ends of two ground jumpers (11) with holes in door (1) and secure each in place using screw
(8), lock washer (9) and flatwasher (10).
4. Secure ladder (3) to door (1) using strap (2).
5. Locate end of door brace (7) to door stop bracket (6) and install pin of chain and pin assembly (5).
6. Secure chain and pin assembly (5) in place using cotter pin (4).
7. Install Roller Latch Assembly (para. 4-18).
TEST
NOTE
The procedure listed below should be performed at the top center and bottom center of the
door and three places along each side of the door.
1. Place a single piece of paper 0.005 inches thick by 2 1/2 inches wide (e.g., a dollar bill) between the
silicone weather gasket and its bearing surface.
4-31
