HOLE AND TEAR REPAIR INSTRUCTIONS

CONNECTOR ASSEMBLY PUNCTURE REPAIR INSTRUCTIONS (CONT)

HOLE AND TEAR REPAIR INSTRUCTIONS (cont) - TM-10-5411-203-13_94

TM-10-5411-203-13 Complexing Kit Passage-ways Complexing Kit Passageways Type II Class A Class B Type I Manual
Page Navigation
88

TM 10-5411-203-13 4-22. HOLE AND TEAR REPAIR INSTRUCTIONS This task covers: Repair INITIAL SETUP Tools Repair kit, tentage (Appendix B, Section III, Item 2) Roller, hand (Appendix B, Section III, Item 6) Tape, measuring (Appendix B, Section III, Item 7) Parts/Materials Cloth, coated Chalk, marking (Appendix D, Item 3) Cloth, wiping (Appendix D, Item 4) Tongue depressor (Appendix D, Item 5) Lumber, softwood (Appendix D, Item 6) Equipment Condition Complexing Kit Passageway removed from shelter. (Refer to para 2-5.) REPAIR WARNING The adhesive has a high alcohol content and is highly flammable Use only in a well ventilated area away from open flame. Do not smoke. Failure to follow these safety precautions could result in dizziness, fainting, severe burns or death. NOTE Adhesive dries quickly. Do not leave lid off adhesive can for more than five minutes. Replace lid on adhesive can immediately after use. Holes 1/8 in. (3.2 mm) across or less in all directions can be repaired using procedures in para 4-21. 1. Measure hole in connector assembly to determine size of patch required. 4-28

Privacy Statement
Press Release
Contact