TM 10-5411-203-13
4-20.
CONNECTOR ASSEMBLY REPLACEMENT INSTRUCTIONS (CONT)
WARNING
Wear safety glasses while drilling out rivets. Failure to do so could result in serious eye
injury or blindness.
2.
Drill out all pop rivets (2) that secure retainer strips (1) and frame assembly (3) to connector
assembly (4).
3.
Remove remaining pop rivet fragments (2).
4.
Remove retainer strips (1) and frame assembly (3).
INSTALL
NOTE
Ensure frame and connector are not secured upside down.
1.
Hold frame assembly (1) against connector assembly (2) and align as shown. Be sure weather barrier (on
connector) and door pivot bushing (on frame) are on same end.
2.
Align retainer strips (3) with holes in frame (1).
3.
Using retainer strips (3) as guides, drill holes through connector assembly (2)
4.
Install new pop rivets (4) though holes in retainer strips (3), connector assembly (2), and frame assembly (1).
NOTE
FOLLOW-ON MAINTENANCE: If required, install Complexing Kit Passageway . (Refer
to para 2-4).
4-25
