CONNECTOR ASSEMBLY PUNCTURE REPAIR INSTRUCTIONS

CONNECTOR ASSEMBLY REPLACEMENT INSTRUCTIONS (CONT)

CONNECTOR ASSEMBLY PUNCTURE REPAIR INSTRUCTIONS (CONT)

TM-10-5411-203-13 Complexing Kit Passage-ways Complexing Kit Passageways Type II Class A Class B Type I Manual
Page Navigation
86

TM 10-5411-203-13 4-21. CONNECTOR ASSEMBLY PUNCTURE REPAIR INSTRUCTIONS This task covers: Repair INITIAL SETUP Tools Repair kit, tentage (Appendix B, Section III, Item 2) Tape, measuring (Appendix B, Section III, Item 7) Parts/Materials Cloth, coated (Appendix D, Item 12) Tongue Depressor (Appendix D, Item 5) Equipment Condition Complexing Kit Passageway removed from shelter. (Refer to para 2-5.) REPAIR WARNING The adhesive has a high alcohol content and is highly flammable Use only in a well ventilated area away from open flame. Do not smoke. Failure to follow these safety precautions could result in dizziness, fainting, severe burns or death, NOTE Adhesive dries quickly. Do not leave lid off adhesive can for more than five minutes. Replace lid on adhesive can immediately after use. 1. Measure hole in connector assembly to see if 1/8 in. (3.2 mm) across or less in all directions. To repair holes larger than 1/8 in. (3.2 mm) across refer to paragraph 4-22. 4-26

Privacy Statement
Press Release
Contact