TM 10-5411-201-14
T.O. 35E4-178-1
4-41.
(cent)
W A R N I N G
Methylethylketone is flammable and toxic and shall be
used only in a well-ventilated area away from all sparks
or open flame.
c.
Sand using sandpaper (Item 17, Appendix E) only if required to
remove material not taken off in preceding step.
d.
Wipe bonding surface with a clean cloth (Item 5, Appendix E)
dampened with solvent (Item 20, Appendix E) and immediately wipe solvent from
surface with a clean, dry cloth.
CAUTION
Seals shall not be washed with any aromatic hydrocarbon
(such as benzene, toluene, or xylene) which will cause
deterioration.
e.
Clean seal with a lint-free cloth by dry wiping prior to bonding.
f.
Brush sealant (Item 18, Appendix E) on mating surfaces of seal and
bonding surface.
g.
When sealant is tacky (approximately 5 minutes), place seal in
position, press firmly to seat and ensure contact with mating surface.
h.
If seal is the type that has a retaining strip, seal shall be bonded
prior to riveting retaining strip,
(Refer to paragraph 4-33 for blind rivet
installation.)
i .
After installing rivets, using hand blind riveter, cover rivets and
seal with sealing compound (Item 19, Appendix E).
4-179
