TM 10-5411-201-14
T.O. 35E4-178-1
4-24.
(cont)
CLEANING, INSPECTION
1.
Clean jack assembly and component surfaces.
2.
Inspect mounting surfaces for corrosion and damage.
3.
Inspect for and replace if necessary:
a.
Missing or damaged components
b.
Corrosion or paint damage.
R E P A IR
Corrosion or paint damage.
(Refer to
LUBRICATION
paragraph 4-44)
Lubricate jack assembly with grease.
ASSEMBLY
1.
2.
3.
4.
5.
6.
7.
Position handle
insert (26) and
(28) and screws
O-rings (30).
(29) on rotating
install lockwashers
(27) .
Install
Position rotating insert (26) in
outside tube (21) and secure
retainer (25) with screws (24).
Install jack screw (20) in inside
tube (19).
Align hole in jack screw (20) with
access hole in inside tube (19)
and install pin (23).
Pack bearing (22) with grease and
place on jack screw (20).
Install inside tube (19) in
outside tube (21).
Position handle
(6) and on jack
holes in handle
screw aligned.
(3 and 4).
(5) in support
screw (19) with
yoke and jack
Install pins
4-116
