TM 10-5411-201-14
T.O. 35E4-178-1
4-15. (cont)
2.
3.
4.
5.
6 .
7.
8.
9.
10.
Assemble light switch (13) with limit switch mounting plate (23) to light fixture adapter (9) using close
nipple (26).
Pass wiring through close nipple (26) into limit switch (13).
Connect wiring. (Refer to paragraph 4-46.)
Position limit switch cover (12) on limit switch (13) and tighten four captive screws (11).
Pass wiring from upper conduit (24) through offset connector (18) at top of light fixture adapter (9) and
position limit switch mounting plate (23) and light fixture adapter (9) with incandescent light spacer (25)
behind it against endwall panel.
Install two screws (21) and lockwashers (22) securing limit switch (13) and limit switch mounting plate
(23) to endwall panel.
Install two screws (19) and lockwashers (20) securing light fixture adapter (9) and incandescent light
spacer (25) to endwall panel.
Pull wiring down into light fixture adapter (9), position offset connector (18). at top of adapter, and
tighten.
Tighten screw (17) at rear of offset connector (18).
4-46
CHANGE 8
S/N 1261 AND SUBSEQUENT
