TM 10-5411-200-14T.O. 35E4-177-14-10.(cont)14.Remove two screws (21) and lockwashers (22) from limit switchmounting plate (23).15.Lower light fixture adapter (9) and offset connector (18) togetherwith limit switch (13) and limit switch mounting plate (23) fromupper conduit (24).16.Remove incandescent light spacer (25).17.Separate light fixture adapter (9) from limit switch (13) and limitswitch mounting plate (23) by unscrewing close nipple (26).1.Clean incandescent light assembly and component systems.2.Inspect mounting surfaces for corrosion and damage.3.Inspect for and replace if necessary:.a.Missing or damaged components.b .Corrosion or paint damage.Corrosion or paint damage.(Refer to paragraph 4-43)6.1.2.3.4.5.7.Assemble limit switch (13) to limit switch mounting plate (23) tolight fixture adapter (9) using close nipple (26).Pass wiring through close nipple (26) into limit switch (13).Connect wiring.(Refer to paragraph 4-46)Position limit switch cover (12) on limit switch (13) and tightenfour captive screws (11).Pass wiring from upper conduit (24) through offset connector (18) attop of light fixture adapter (9) and position limit switch mountingplate (23) and light fixture adapter (9) with incandescent lightspacer (25) behind it against endwall panel.Install two screws (21) and lockwashers (22) securing limit switch(13) and limit switch mounting plate (23) to endwall panel.Install two screws (19) and lockwashers (20) securing light fixtureadapter (9) and incandescent light spacer (25) to endwall panel.4-25
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
