TM 10-5410-284-13&P
TM 10602A-13&P
LIGHTWEIGHT MAINTENANCE ENCLOSURE (LME)
0020 00
EXTENSION OF LENGTH
0020 00-1/2 blank
THIS SECTION COVERS:
Inspect, Replace, Repair
INITIAL SETUP
Extension of Length unpacked
Maintenance Level
Materials/Parts
Unit
Tools and Special Tools
LME Repair Kit (WP 0029, Table 0027 00-2, Item 1)
Tentage Repair Kit (WP0029, Table 0027 00-2, Item 2)
GENERAL
This procedure contains information and instructions to keep the extension of length in good working
order by inspecting, repairing, or replacing the entire extension of length.
INSPECT
Inspect the extension of length (1) for tears, cuts, perforations and open seams. Check condition of
becket loops (2) and security and serviceability of grommets (3). Inspect seams (4) along reinforcing
webbing (5) for security.
REPLACE
If the extension of length has tears or cuts longer than 12 inches, deteriorated becket loops, or open
seams, replace the entire extension of length.
REPAIR
If cuts or tears of less than 12 inches but more than 6 inches are noted, seams are opening, or grommets
are damaged, refer the extension of length to direct support maintenance.
Repair any cuts, tears or perforations in the extension of length of up to 6 inches long as described in
Work Package 0018 00, using the LME Repair Kit. Also make temporary repairs to seam openings (not
longer than 6 inches) and loose hardware as described in Work Package 0018 00. Replace the hitch clip
pin and holder if necessary, as described in Work Package 0018 00.
END OF WORK PACKAGE
