TM 10-5410-284-13&PTM 10602A-13&PLIGHTWEIGHT MAINTENANCE ENCLOSURE (LME)0023 00POWER DISTRIBUTION BOX0023 00-1WARNINGTHIS SECTION COVERS:Inspect, ReplaceINITIAL SETUPPower Distribution Box, in container or in operationMaintenance LevelUnitMaterials/PartsNo. 10-24 Nylon lock nutTools and Special ToolsTool Kit, General Mechanic’s (WP 0029, Table 0027-2, Item 3)GENERALThis procedure contains information and instructions to keep the LME power distribution box in goodworking order by inspecting and replacing the handle, cord grip, side strap assembly, or the entire powerdistribution box. Lethal voltage is present when the power distribution box is connected toa power source. Disconnect the power source before affecting anyrepairs to the box. Serious injury to personnel or death may result fromtouching any component under power.INSPECTInspect the power distribution box housing (1) and handle (2) for damage. Check the side strap (3) forpresence and condition. Open cover (4) and check latch (5) for proper operation. Visually inspect insideof power distribution box for cleanliness and corrosion. Notice condition of circuit breakers (6), powerreceptacles (7), and light switch (8). Refer a power distribution box with damaged or inoperative circuitbreakers, receptacles, or light switch to direct support maintenance. Inspect the 25 foot (9) and the 10foot (10) extension cords for cuts or damaged ends. REPLACEReplace a frayed or otherwise damaged side strap assembly (3) as required.To replace a defective handle (2), remove the self-locking hex nuts (11) and truss head screws (12)securing handle (2) to the box (1). Retain truss head screws.Remove old handle and place new handle into position.Install and tighten three new self locking hex nuts (11). Install three truss head screws.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business