REPAIR OF PUNCTURES IN FABRIC ASSEMBLIES

REPAIR OF HOLES AND TEARS IN FABRIC ASSEMBLIES

TM-10-5410-230-13 Standard Integrated Command Post Systems Bootwalls Types I II & IV Classes 1 (Green) and 2 (Tan) Manual
Page Navigation
45

TM 10-5410-230-13 4-3. REPAIR OF PUNCTURES IN FABRIC ASSEMBLIES. This task covers: Repair of punctures 1/8 in. (3.2 mm) diameter or less NOTE This procedure applies to all Boot Wall types. INITIAL SETUP Tools: Tool Kit, Canvas Workers (Appendix B, Section III, Item 3) Materials/Parts: Cloth, coated Scrub brush (Appendix E, Item 2) Soap, toilet, hand, cake (Appendix E, Item 1) Equipment Conditions: Although the fabric assemblies can be repaired during operational use of the Boot Wall when necessary, it is recommended that the fabric be repaired when the Boot Wall is not in use (refer to Chapter 2 for removal instructions). The fabric assemblies should be clean and dry. WARNING The adhesive has a high alcohol content and is highly flammable. Use only in well ventilated areas away from open flame. Do not smoke. In case of dizziness, leave area immediately and allow to ventilate. Failure to observe this warning may result in severe injury or death. b. Clean fabric (1) around hole (2) with mild soapy water and brush, and allow to air dry c. Using tongue depressor (3), dab adhesive (4) onto hole (2). c. Work adhesive (4) into fabric (1) and hole (2) immediately and bridge hole (2) with adhesive (4) to seal it. d. Allow adhesive (4) to dry. 4-3

Privacy Statement
Press Release
Contact