TM 10-5410-229-13&P
2-6. ASSEMBLY AND INSTALLATION INSTRUCTIONS - Cont’d
(2)
Lay the three frame assemblies on the ground. Put the center wall frame assembly (1) in between
the two end wall frame assemblies (2). Make sure the left hand purlin (3) on each end wall frame
assembly (2) is on top.
(3)
Unfold the rafter assemblies (4) on each frame assembly away from the center as far as they will go.
Each of the three frame assemblies should form a "V". Do not unfold the legs at this time.
(4)
Lock the rafter assemblies (4) into place at.the peak fitting (5) by engaging the teeth and turning the
handles (6) on each fitting downwards until they are tight, and the rafter assemblies (4) cannot move.
Repeat this process for each of the three frame pieces.
2-16
