M1070 HET ARMOR KIT
II113400
Rev. D
a. Installation
1. Install lift brackets, stud plates, and PLGR antenna mount brackets onto roof panel as follows (see
a. Install four lift brackets (1) onto roof panel (2) and secure each with one bolt (3), flat washer (4), and
locknut (5). Torque locknuts to 35 lb-ft.
b. Install seven stud plates (6) onto roof panel (2) and secure each with one jam nut (7). Temporarily tighten
jam-nuts (7).
c. Install two PLGR antenna mount brackets (8) and secure each with two flat washers (9) and
locknuts (10). Ensure locknuts are snugged down, but do not torque further at this time.
2
7
1
10
9
5
4
2
7
8
6
6
3
JUNE 2005
