M1070 HET ARMOR KIT
II113400
Rev. D
4.
Apply rubber seal to windshield armor panel as follows (see Figure 3-5):
a. Apply rubber seal (1) onto outside surface of cab windshield frame panel. (the total used will be approx.
20 ft 6 in.) Run stripping along edge of windshield bracket but not on top of them. The seal will make
continuous 45-deg bends in the upper left and right corners, but should be cut in the lower left and right
90-deg corners. Use black urethane sealant around windshield wiper studs, if necessary.
1
JUNE 2005
