TM 10-5410-221-24
SHELTER BODY ASSEMBLY
Section I. FOLDING PANEL ASSEMBLIES
(1) Remove washer (2) and retainer washer (3)
General
from captive screw (1).
This section provides instructions for replacement of
(2) Remove screw (4), rivets (6, 7) which secure
those items considered as part of the folding panel
hinge half (10) to door panel assemblies. Remove blind
assemblies. They consist of four door panel assemblies,
folding end jack assemblies, folding side panels, folding
(3) Remove hinge pin (8) and separate hinge
end panels, folding floor panels, and folding roof panels
halves (10, 11), and torsion springs (9).
(4) Remove screw (12), washer (13) and remove
ground rod (14) from panel.
Door Panel Assemblies
(5) Remove screw (15) to remove upper bar
retainer (17) from panel. Remove rivet (19) and remove
a. General. The door panel assemblies are
lower bar retainer (20) and retainer shim (21). Remove
a metal faced honeycomb core panel. They consist of a
weather seal assembly on the door inner edge, a hinge
(6) Remove screws from lock assembly plate and
assembly, door stops, window assemblies with blackout
remove lock assembly from door. Disassemble door
curtains, and an anti-back draft valve located on one of
lock assembly according to sequence of index numbers
the panel assemblies at each side of the shelter (fig. 10-
assigned to detail A and observing the following.
(a) Remove screws (22, 23) and re-move
b. Removal. Remove the door assemblies
handle bar (24). Remove nut (25), washer (26), and
according to sequence of index numbers as-signed to
screw (27); remove locking bar (28), handle bail (29),
keeper plate (30) and stop arm (31).
(1) Remove grounding straps located at the upper
(b) Remove screw (32) and remove idler
left and right hand corners of the doors.
block (33), stop arm (34), keeper plate (30) and locking
(2) Remove the captive screws (1, fig.
blade (3F).
10-2) on
the side panel side of
the hinge (11) and
(c) Remove screw (23) to remove interior
the pan head screws securing the hinge to the edge of
handle bar (24), and handle bail (29).
(7) Remove rivet (36), window frame (37), spacer
(38) and window (39). Remove blackout curtain pile tape
folding side panels.
(41, 42) by peeling from window frame (37) in
c. Disassembly.
Disassemble the door
panel assemblies for replacement of damaged parts
(40) by running a knife or other sharp instrument
according to sequence of index numbers as-signed to
between close out and paper honeycomb core.