TM 9-4931-374-13&P
NOTE
White wire (4) is soldered into compression connector
(5) along with four green wires (6).
3
WHITE WIRE (4) AND THREE (RED, BLACK, AND BLUE OR
ORANGE) WIRES (7). Install in four contact recesses (8) of insulator
assembly (9) according to table 3-6.
4
FOUR PRESSURE CONTACT SCREWS (10).Tighten.
Table 3-6. Wire Polarity
NOTE
5
INSULATOR ASSEMBLY (9). Install in
Use this table to get correct
lower half of body (11) with wide notch
polarity on wires.
(12) to left (viewed from cable side).
Contact Recess
6
GROUND STRAP (13). Position over
Designation
Wire Color
tapped hole in lower half of body (11).
1
Black
7
SCREW (14). Install.
2
Red
3
Blue or Orange
4
White
3-301
