TM 9-4931-374-13&P
1
TWO BRACES (1) AND POWER SUPPLY (2). Clamp together
temporarily with clearance holes in braces over existing screws in
power supply.
2
POWER SUPPLY (2). Drill six 0.281-in. (0.714-cm) diameter holes
(three on each side) in flanges, using 0.281-in. (0.714cm) diameter
holes in braces (1) as a guide.
3
TWO BRACES (1). Remove.
CAUTION
The power supply operates on 120-volt electrical power.
Some power supplies when received new may be wired
internally for 220-volt electrical power and must be
rewired.
4
POWER SUPPLY (2). If necessary rewire unit internally for 120volt
operation. Refer to TM 11-6130-246-12 for instructions.
3-211
