TM 9-4931-374-13&P
3-15. SHOP SET-[DOOR MODIFICATION--MAINTENANCE INSTRUCTIONS (cont)
DISASSEMBLY (cont I
CAUTION
NOTE
Do not remove blind inserts
unless
necessary
for
Each blind insert is installed
replacement.
in a large hole which has two
small holes on each side of it.
9
FOUR BLIND INSERTS (12). Remove by
These three holes must be
drilling out with a 0.375-in. (0.953-cm)
drilled clear of cured adhesive
diameter drill.
as described in steps 10 and
11. This procedure pertains
to each blind insert to be
removed.
10
LARGE HOLE (13). Drill a 0.391-in. (0.993-cm) diameter hole 1.50 in.
(3.81 cm) deep.
11
TWO SMALL HOLES (14).
a. Drill a 0.125-in. (0.318-cm) diameter hole 0.25 in. (0.64 cm) deep.
b. Insert a 0.062-in. (0.157-cm) diameter drill and drill a hole at an angle
to intersect the large hole (13).
3-156