TM 9-4931-374-13&P
10
FOUR
NUTS
(15),
FOUR
FLAT
WASHERS (16), FOUR SCREWS (17),
FLAT WASHERS (19).
Replace if
missing, damaged, or corroded.
11
MAGNIFIER INSTRUMENT (20).
a. Refer to vendor's supplied instructions
for repair procedures.
b. Refer to SC 4931-95-CL-A21
for
replacement if not repairable.
MODIFICATION OF TABLES I
NOTE
Steps 1 thru 8 are used only
for the initial installation or
when the tables have been
replaced with new items.
1
MACHINIST'S VISE (1). Position on left
table (2) as follows: the front edge of vise
The tables are purchased
should be flush with front edge of left
from various manufacturers
table; center line of vise should be 64.75
and there may be slight
in. (164.47 cm) from personnel door end
variations.
of left table.
The designation of left and
right tables is determined by
looking into the shop set from
the cargo door.
3-139