TM 9-2330-390-14&P
4-130. STARTER REPLACEMENT.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Equipment Conditions:
Materials/Parts:
Negative (-) ground cable disconnected from battery
(rear dolly) (see paragraph 445).
Marker tags (Item 28, Appendix F)
Engine removed (front dolly) (see paragraph 4-115).
One springwasher
Spiral case removed (see paragraph 4-128).
Tools/Test Equipment:
General mechanic’s tool kit (Item 30, Appendix G)
NOTE
All wires should be tagged before removal. Refer to paragraph 4-18 for tagging
Instructions.
1.
Remove nut (2), springwasher (3), wiring harness red wire (4), and positive (+) battery cable (5) from starter
(1). Discard springwasher.
2.
Disconnect wiring harness connector (6) from starter (1).
4-382
