TM 9-2330-390-14&P
4-109. HYDRAULIC LINES REPLACEMENT (Con't).
3.
4.
5.
Disconnect hose assembly (15) from straight
connector (20) at quick disconnect fitting (19).
6.
Disconnect hose assembly (13) from elbow (21).
7.
Lace replacement hose assemblies (13 and 15)
to hose assemblies being removed. Remove
hose assemblies from inside abrasion sleeve
(10) while pulling through replacement hose as-
semblies.
8.
9.
10.
11.
12.
Disconnect hose assembly (13) from union (12)
(front dolly) or swivel nut elbow (18) (rear dolly) at
outlet section (16) of hydraulic control valve (8).
Release hose bundle from supported position.
Remove tie-down straps from abrasion sleeve
(10). Discard tie-down straps.
Connect hose assembly (13) to elbow (21).
Connect hose assembly (15) to straight connec-
tor (20).
Connect hose assembly (13) to union (12) (front
dolly) or swivel nut elbow (18) (rear dolly).
Connect hose assembly (15) to union (14) (front
dolly) or elbow (17) (rear dolly) at outlet section
(16) of hydraulic control valve (8).
Install new tie-down straps around abrasion
sleeve (10). Raise hose bundle and secure in
supported position, as noted during removal.
4-293
