TM 9-2330-390-14&P
4-109. HYDRAULIC LINES REPLACEMENT (Cont).
NOTE
A suitable container should be used to catch any draining hydraulic fluid. Ensure that
ail spills are properly cleaned.
During removal, tie-down straps must be removed from hydraulic hose assemblies,
electrical cable assembiles, and abrasion sleeve, as required. Hose assemblies
Inside abrasion sleeve (hose bundle) must also be removed from attachment to
muffler cover and angle bracket at hydraulic reservoir (rear doily only), as required.
Ensure that new tie-down straps are used during Instaliation. Also ensure that hose
assemblies are properly supported, as noted during removal.
1.
Drain hydraulic reservoir (see paragraph 4-111).
2.
Disconnect hose assembly (1) from elbow (2) at inlet (top) of hydraulic pump (3).
3.
Disconnect hose assembly (1) from straight connector (5) at reservoir (4). Remove hose assembly.
4.
Connect hose assembly (1) to straight connector (5).
5.
Connect hose assembly (1) to elbow (2).
4-288