TM 9-2330-390-14&P
Section III. GENERAL MAINTENANCE INSTRUCTIONS
Paragraph
Number
Paragraph Title
Page
Number
4-7.
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-4
4-8.
Work Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-5
4-9.
Cleaning Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-6
4-10.
Preservation of Pans . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-8
4-11.
Painting
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-8
4-12.
Inspection Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-8
4-13.
Disassembly and Assembly Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-9
4-14.
Repair Instructions.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-9
4-15.
Lubrication Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-9
4-16.
Application of Adhesives . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-9
4-17.
Tool Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-10
4-18.
Tagging Wires and Hoses.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-11
4-19.
Soldering
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-11
4-20.
Heat Shrink able Tubing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-11
4-21.
Electrical Ground Points . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-12
4-22.
Lines and Ports . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-12
4-23.
Airbrake System Leakage Check . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-13
4-24.
Antiseize Tape . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-13
4-25.
Fluid Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-13
4-26.
Electrical Repair
4-14
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-7.
GENERAL.
a.
These general maintenance instructions contain general shop practices and specific methods you must
be familiar with to properly maintain the M1022A1 Dolly Set. You should read and understand these practices and
methods before performing any Unit Maintenance procedures.
b.
Before beginning a task, find out how much repair, modification, or replacement is needed to fix the
equipment. Sometimes the reason for equipment failure can be seen right away and complete teardown is not
necessary. Disassemble equipment only as far as necessary to repair or replace damaged parts.
c.
In some cases, a part may be damaged during removal. If the part appears to be good, and other parts
behind it are not defective, leave it in place and continue with the procedure. Here are a few simple rules:
(1)
Do not remove studs unless loose, bent, broken, or otherwise damaged.
(2)
Do not remove bearings or bushings unless damaged. If you need to remove them to access pans
behind, carefully pull out bearings and bushings.
(3)
Replace all gaskets, lockwashers, locknuts, seals, cotter pins, and preformed packings.
4-4
