1.
2.
3.
4.
5.
6.
7.
Section IL MANUFACTURING
Dimensions are shown in inches.
TM 9-2330-275-14&P
INSTRUCTIONS (Con’t)
Tolerances are ± 0.02 in. for two-place decimals and 0.-010 in. for three-place decimals unless
otherwise stated.
Angular tolerance is ± 1 degree.
Weld four P/N 12436726-1 and four P/N 12436727-1 to suspension bar per
MIL-STD-1261, Class III, according to the specifications below.
Remove all burrs and sharp edges.
After welding, apply Chemical Agent Resistant Coating primer.
After primer dries (approximately six hours), apply Chemical Agent Resistant Coating
camouflage basecoat, Green 383, color 34094.
Figure G-S. Front Shelter Suspension Bar.
G-7
