TM 9-2330-275-14&P
1.
2.
3.
Section Il. MANUFACTURING INSTRUCTIONS
Make from stranded single-conductor #14 AWG insulated copper wire, NSN 61454-00-152-6499,
P/N M1348/1-5.
Cut to 8.0 in. (203 mm) length.
Strip and tin both ends.
Figure G-1. Wire.
1.
2.
3.
4.
5.
6.
Dimensions are shown in inches and centimeters.
Make from shock absorber, NSN 2510-00-903-0487, P/N 10947382, according to the specifications
below.
NOTE
Dimensions aline with bottoms of circular bands.
Measure 6.50 in. from bottom of shock absorber and mark a line.
Measure 8.50 in. from bottom of shock absorber and mark a line.
Use tape to mask two circular bands 0.25 in. (6.35 mm) wide around shock absorber inner cylinder.
Brush-paint circular bands around shock absorber using Polyurethane Coating, Black, NSN 8010-
01-229-7540, P/N MIL-C-53039. Allow to dry completely. Remove masking tape.
Figure G-2. Shook Absorber.
G-3
