TM 9-2330-275-14&P
4-86. HYDRAULIC CYLINDER REPLACEMENT (M832 AND M840) (Con’t).
4.
5.
6.
7.
8.
9.
Remove two cotter pins (7) and washers (8) and pin (9) from hydraulic cylinder (10), Discard cotter pins.
NOTE
Use a suitable container to catch any fluid that may spill when disconnecting
hydraulic lines.
Disconnect coupling (12) of hydraulic hose (13) from elbow (11).
Remove elbow (11) and reducer (17) from hydraulic cylinder (10).
Remove screw (14), Iockwasher (15), cotter pin (22), washer (21), and pin (16) from lower end of hydraulic cylinder
(10). Discard cotter pin and Iockwasher.
Compress hydraulic cylinder (10) and remove from vehicle.
For the M832 (SN J089-001 thru 159 and J017-160 thru 350 only), if hydraulic cylinder boot (19) is undamaged,
remove two clamps (18 and 20) from boot (19) and remove boot (19) from hydraulic cylinder (10). Retain boot
for installation on new hydraulic cylinder.
4-237
