TM 9-2330-275-14&P
4-74. ADHESIVE LABEL AND PUMP INSTRUCTlON PLATE REPLACEMENT (Con’t).
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective
goggles and gloves, and use only In a well-ventilated area. Avoid contact with skin,
eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open flame or
excessive heat. The solvent’s flashpoint is 100°F-138°F (38°C-59°C). If you become
dizzy while using dry cleaning solvent immediately get fresh air and medical help. If
solvent contacts your eyes, immediately wash them and get medical aid.
2.
Use dry cleaning solvent to remove any adhesive residue.
NOTE
If installing a self-adhesive label, skip step 1.
b.
INSTALLATION
WARNING
Adhesive causes immediate bonding on contact with eyes, skin, or clothing and also
gives off harmful vapors. Wear protective goggles, and use adhesive in a well-
ventilated area. If adhesive gets in your eyes, try to keep them open, flush them with
water for 15 minutes, and get medical attention. Adhesives and sealing compounds
can bum easily and can give off harmful vapor. To avoid injury, keep adhesives and
sealing compounds away from open firs and use them in a well-ventilated area.
1.
Use adhesive to install instruction plate (1) on hydraulic pump (2).
2.
Peel backing from label(s) (3, 4, or 6), and install label(s) on drawbar (5).
4-195
